INSPIRA® Fusible “No Show” Mesh Cut-A-Way Stabilizer part #-
specialty type: Optional Accessories

INSPIRA® Fusible “No Show” Mesh is a semi-sheer iron-on polyester stabilizer that is very soft yet strong. It is used as a permanent backing and is ideal for garments and fabrics with stretch as well as applications that will be close to the skin. The translucent nature of this stabilizer eliminates the bulk, stiffness and shadowing characteristic of other types of permanent stabilizers. INSPIRA® Fusible “No Show” Mesh stabilizer is applied to the back of your fabric prior to hooping, preventing distortion during the hooping process. No messy spray adhesives or glues needed!
Sizes available:
Fusible “No Show” Mesh 12”x12 yards (620111896)
Fusible “No Show” Mesh 8”x12 yards (620111796)
Best for these applications:
  • Light to medium stitch count embroideries.
  • Sweater knit, jersey, cashmere, wool crepe, silk, satin, silky polyesters, rayon, crepe de chine, batiste, voile, stretch denim and corduroy, terry cloth, sweatshirt fleece and microfiber.
  • Some applications might require an additional layer of stabilizer.
Directions for use:
  1. Cut a piece of INSPIRA® Fusible “No Show” Mesh approximately 1” larger than the design area.
  2. Place the fusible (shinier) side of the stabilizer onto the wrong side of the fabric. Using a pressing cloth apply the stabilizer to the back of the project using a low to medium dry iron, silk setting. Press, hold then lift iron (without sliding) until entire area is fused.
  3. Hoop the fabric without stretching. Stitch the embroidery.
  4. After the design is complete, remove from hoop and reheat the stabilizer using a dry iron, silk setting. Gently peel back the excess stabilizer; trim close to the stitching.
  5. Follow normal care instructions for washing and drying or dry cleaning according to fabric type.

latest accessories