How to use:

1. Select a straight stitch, snap on the Rolled Hem Foot and engage IDT™ system (if available on your machine). If needed, press only the beginning of the hem to 2, 3 or 4mm wide,depending on the size of your foot. Place it flat in the groove under the foot and sew, pulling the cut edge of the fabric into the scroll of the hemmer. Lower the presser foot and continue sewing while holding for a few stitches. Lower the needle into the fabric to hold it in place. Then raise the presser foot, keeping the cut edge up in front of the foot.
2. Do not allow fabric to run under the right half of the presser foot.